Não conhecido declarações factuais Cerca de batteries
Não conhecido declarações factuais Cerca de batteries
Blog Article
The active material on the battery plates changes chemical composition on each charge and discharge cycle; active material may be lost due to physical changes of volume, further limiting the number of times the battery can be recharged.
A battery is a device that holds electrical energy in the form of chemicals. With the help of an electrochemical reaction, it converts stored chemical energy into direct current (DC) electrical energy.
It is also known as a rechargeable battery because it can be recharged after the battery’s energy is depleted. They are used as inverters for power supply as well as standalone power sources.
Batteries and similar devices accept, store, and release electricity on demand. Batteries use chemistry, in the form of chemical potential, to store energy, just like many other everyday energy sources. For example, logs and oxygen both store energy in their chemical bonds until burning converts some of that chemical energy to heat. Gasoline and oxygen mixtures have stored chemical potential energy until it is converted to mechanical energy in a car engine. Similarly, for batteries to work, electricity must be converted into a chemical potential form before it can be readily stored. Batteries consist of two electrical terminals called the cathode and the anode, separated by a chemical material called an electrolyte. To accept and release energy, a battery is coupled to an external circuit.
g., a lamp or other device) must be provided to carry electrons from the anode to the negative battery contact. Sufficient electrolyte must be present as well. The electrolyte consists of a solvent (water, an organic liquid, or even a solid) and one or more chemicals that dissociate into ions in the solvent. These ions serve to deliver electrons and chemical matter through the cell interior to balance the flow of electric current outside the cell during cell operation.
Batteries have much lower specific energy (energy per unit mass) than common fuels such акумулатори as gasoline. In automobiles, this is somewhat offset by the higher efficiency of electric motors in converting electrical energy to mechanical work, compared to combustion engines.
It can be used for high- and low-drain devices but can wear out quickly in high-drain devices such as digital cameras. These batteries have a higher energy density and longer life, yet provide similar voltages as zinc-carbon batteries.
Disposing of a battery via incineration may cause an explosion as steam builds up within the sealed case.
The sealed valve regulated lead–acid battery (VRLA battery) is popular in the automotive industry as a replacement for the lead–acid wet cell.
These types of batteries have a terminal voltage that drops almost to the end of the discharge during a discharge of about 1.2 volts. Although they are rarely used, they are cheap and have a much lower discharge rate than NiMH batteries.
Vanadium-Redox Flow: These batteries integrate energy from renewable resources, such as solar and wind farms. For years, sensitivity to high temperature, high cost, and smaller storage capacity limited the widespread use of these batteries. PNNL researchers developed a new generation of vanadium flow battery with a significantly improved energy density and wider temperature window for operation, that is capable of deployment at grid scale.
Charging voltage refers to the maximum voltage that must be applied to the battery in order to charge the battery efficiently. Basically, 4.2 V considers the best charging voltage.
Secondary cells are made in very large sizes; very large batteries can power a submarine or stabilize an electrical grid and help level out peak loads.
Sony has developed a biological battery that generates electricity from sugar in a way that is similar to the processes observed in living organisms. The battery generates electricity through the use of enzymes that break down carbohydrates.[37]